// ============================================
// Tapo Ceiling Mount - Interior Clamps
// ============================================
// Two identical curved clamps that sit above the ceiling, one on each side of
// the hole. Each one carries one captive M4 nut and bears on the upper ceiling
// surface beyond the hole edge. A lip under each clamp drops into the hole,
// like the plate lip from below, so the clamp seats itself.
//
// With clamp_link = true a thin flexible line joins the two clamps across the
// hole center. They print as one part and go into the ceiling together: push
// one clamp up through the hole, then the other one follows on the line.
//
// Print orientation: flat top on the bed. The link prints on the bed and the
// lips point up. No support is needed. Press the nuts in after printing.

parameters_only = false;
include <tapo_ceiling_mount_parameters.scad>;

module tapo_inner_clamp() {
    inner_clamp_body();
}

// Thin flexible line on the top face that joins the two clamps.
module clamp_link_line() {
    translate([-clamp_inner_r - 2, -clamp_link_w / 2, clamp_boss_height - clamp_link_t])
        cube([2 * (clamp_inner_r + 2), clamp_link_w, clamp_link_t]);
}

// Both clamps in their installed positions, joined by the link.
module tapo_inner_clamp_pair() {
    tapo_inner_clamp();
    rotate([0, 0, 180]) tapo_inner_clamp();
    if (clamp_link) clamp_link_line();
}

tapo_inner_clamp_pair();